Automatic Glass Edging Machine
Designed to take the sharpness off the edges of both sides of a piece of cut glass. There are 2 high speed emery belts set in a V to do both edges in one pass. Perfect machine to polish insulated glass before it is assembled and also tempered glass.
Power: 220 Volts 60 Hz.
Maximum glass size is 63″ x 85″.
Belt size: 82″ x 3.5″.
New Four Spindle Glass Edging Machine
Does Edge and corner grinding of plate glass,finishing coarse grinding, fine grinding and polishing at one time. The flat surface after polishing is close to bright and clean degree of matrix. Glass thickness: 3 mm to 19 mm. Minimum glass processing size: 3″ x 3″
Lease for $500
New Nine Spindle Glass Straight Line Polishing Machine
Designed for straight edges or 45 degree angles on flat glass. The round grinding, polishing and angle can be completed in a procession. The speed can be widely adjusted by the step less regulator. The front rails can be adjusted for a variety of glass thickness from 3mm to 19mm. Has an automated system for gripping, lubrication, steady voltage. Glass processing size minimum: 4″ x 4″. Glass processing size maximum: 120″ x 120″. Glass thickness: 3 mm to 19 mm.
Lease for $868
Somaca 2 + 2 Edger
Machine was in good working condition when taken from service.
Power: 230 Volt 3 Phase.
Size: 225″long X 30″Deep X 88″ high.
Glass length: 10″ to 100″.
Glass height: 4″ to 72″.
Glass thickness: 2.16mm to 4.57mm.
Used Besana R10/OGM Pencil Edger
Unit is a ten spindle. Manufactured in 1993. Located in Georgia. Owner states it is in good working condition.